T-626 Flat Surface Tape Applicator

The model T-626 tape applicator is designed to apply a wide variety of pressure-sensitive tapes to flat surfaces. Tape strips can be applied continuously or short strips with gaps can be applied to each product as required. This tape applicator can be mounted over a moving product, a conveyor, or used on custom taping equipment to move the applicator across the product.

The T-626 is a versatile piece of equipment ideal for use across a range of packaging applications.

T-626 Specifications

• CE Approved
• 24v DC, 2A or 120 VAC, 1A, 50/60Hz
• Air: 60 PSIG (4.1 bar gauge) 0.4 SCFM (11.2 liters/min)
• Tape roll diameter: 18” (452.7mm) on a 3” (76.2mm) diameter core
• Minimum center-to-center distance between two strips of tape:
• T-626-1 – 3⅝” (92mm), T-626-2 – 4½” (114mm
• Weight: T-626-1 – 16 lbs. (7.3 kg)
• T-627-2 – 20 lbs. (9.1 kg)
• Minimum Tape Placement from Product Leading Edge: 0.125” (3mm)
• Tape End Tolerance: ± 0.09” (2.3mm)
• Minimum Tape Length: 1” @ 100 fpm
• Maximum application speed: 350’ per minute
• NOTE: Accuracy and speed are dependent on product, tape and material handling. The product to be taped must be firmly driven under the taping applicator at all times to pull the tape from the applicator. Alternatively, the product to be taped must be firmly secured while the taping applicator is driven over the product. For optimum performance on non-rigid products, it is recommended that the sum of the tape strip length and inset length be greater than 2” (50 mm). Tape cutoff: Tape cut-off creates a serrated edge on the tape end. The tape gripper will leave some marks approximately ½” in from the leading edge of the tape.

Check out our Technical Data Sheet, or contact Straub to discuss system capabilities specific to your production needs.