T-628 Flat Surface Tape Applicator

The T-628 Tape Applicator is designed to apply a wide variety of pressure-sensitive tape to flat surfaces. Tape strips can be applied continuously or short strips with gaps can be applied to each product as required. This tape applicator can be mounted over a moving product on a conveyor or used on custom-designed taping equipment moving the tape head across the product.

The Model T-628 is designed to run different types of tape and eliminate cutting of certain products when cutting the tape. During operation, the machine applies the tape, cuts it using a serrated knife, and then seals the tape down to the product.

T-628 Options & Specifications

• Powered pre-stripper to pull the tape from the roll minimizing the force on the product.
• Air Power: 60 PSIG (4.1 bar gauge) 0.4 SCFM (11.2 liters/min)
• Electrical Power: 24v DC, 2A or 115v AC, 1A, 50/60Hz
• Control system with tape low switches to toggle between two heads when the tape roll runs low for non-stop running
• Tape fail sensors.
• Tape low sensors.
• Control systems to start and stop the tape application.
• Liner rewind for double-coated tapes.
• Edge folding device.
• NOTE: The product to be taped must be firmly driven under the taping head at all times. Alternatively, the product to be taped must be firmly secured while the taping head is driven over the product. For optimum performance on non-rigid products, it is recommended that the sum of the tape strip length and inset length be greater than 2” (50 mm). The product pulls the tape from the roll.

Check out our Technical Data Sheet, or contact Straub to discuss system capabilities specific to your production needs.